![]() Top left in pcb view, ICSP connector for 16u2: top right OK there isn’t enough info on the pinout diagram to fix this so its I should probably add this as the url so people know which board this part is for as well (when I checked that is the site with a wrong url that is listed, I’ll correct that too). Ah! This board doesn’t seem to be either of those listed but this third board which does match this pcb layout:Īlthough then we are missing the usb connector that sticks out past the end of the board in silkscreen. ![]() Also the mounting holes are missing (even if they are only on the silkscreen as usual so you can drill the hole if you want). ![]() The two end connectors (the 6pin and the 8) look to be reversed on the Fritzing board. There is a reset switch over the left side set of 6 pads (unless it is connecting to the pads? Also from the picture the board I made seems to be wrong. OK now I’m really confused the pin numbers above are wrong, the pins only go up to 386, so I pulled up the boards referenced by Old_Grey but they don’t match the PCB layout. Is it only the ISCP connector you think should go? On the shield version we could move the pads to silk screen so they could at least have holes if they needed too.Įdit: Is it a correct assumption that these share the same named pins else where and thus should be bused to the other pins? I’m inclined to do the renumber then split them that way. Old_Grey: there isn’t any reason to not have two parts, one with the ISCP and one without. Works on my Uno with a similiar platformio.OK, I’ll change it to match your pinout. (see Windows device manager).ĮDIT: In my test I had to say debug_port = \\.\COM14 when using COM14 so that GDB is happy.Īnd as code / src\main.cpp #include "Arduino.h" Whereas you have to replace SERIAL_PORT with the actual serial port name of the Mega on your computer, e.g. So you need to move your normal Serial output to another hardware serial ( Serial2?) on the Mega.Īs a start I’d suggest you debug just a blink sketch to verify the setup. Arduino Serial class) cannot be used in your program together with the debugger.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |